Dino Egg Mold
Dino Egg Mold
Ever want to take a bath with some real relaxation? This is the best way to get the body in a zen state. By using this mold you can create an unlimited amount of Bath Bubble Bombs!
3 piece molds include the following
Single piece molds are the sleeve and the detailed piece together allowing for flat back pieces. Insert mix into the hybrid mold (similar to vacuum form) and then flip upside down to get the mix removed.
Material: This is made out of PLA, a type of plastic that is used with 3D printers. We print at high quality settings, but for smooth surfaces some light sanding will need to be done. This is all personal preference.
Measurements: We offer multiple sizes, please see drop down for different choices. We sizs our molds based on the inserts themselves. This means if you get a 3” mold it is likely to be 2.98” since it need to include the wall thickness of the insert. As its difficult to keep sizes consistent from various molds, we measure from tip to tip on the longest point of the mold.
Processing time: All our items are made to order. Typically, our processing time is 1-5 days days for 3D printed items and 1-3 days for laser printed items, but if there is an updated change to this we will let you know. We try to process these as fast as possible and will send you a message when we drop off the items.
Design: This design was printed, packaged and shipped in the US by Parton Prints.
Disclaimers: Some molds require sanding after printing to smooth curves or eliminate seams.
Actual bath bombs not included. Mold color will vary.
This is an item that can ONLY be hand washed in cold water. Before using sand and hand wash and then air dry. Between use to clean please wash in cold water and towel dry. Do not put in dishwasher or use hot water to wash, it can warp and ruin the mold. Molds are printed with PLA and do not tolerate high heat or exposure to extended direct sunlight well.
These are made out of PLA. They are made to to be used for bubble bath molds, shampoo bar, shower bomb, shower steamer and sometimes bubble bars only. If you use anything else like resin, soap, or candles you’ll want to use a release to allow it not to get stuck.
Filament used: We use filament from FILAfi filament here in Atlanta, GA. Check them out @ www.filafi.com.
Facebook/Instagram/Tiktok @partonprints and @moldingmolds
Join our facebook group here: https://www.facebook.com/groups/1035661493963119